1He is able to complete this work sometimes in eight hours, sometimes in
ten,
and again sometimes in twelve. In order that the heat of the fire should not
burn his face, he covers it entirely with a cap, in which, however, there are
holes through which he may see and breathe. At the side of the hearth is a
bar which he raises as often as is necessary, when the bellows blow too violent
a blast, or when he adds more ore and charcoal. He also uses the bar
to draw off the slags, or to open or close the gates of the sluice, through
which the waters flow down on to the wheel which turns the axle that com
presses the bellows. In this sensible way, iron is melted out and a mass
weighing two or three centumpondia may be made, providing the iron ore
was rich. When this is done the master opens the slag-vent with the tapping
bar, and when all has run out he allows the iron mass to cool. Afterward
he and his assistant stir the iron with the bar, and then in order to chip off
the slags which had until then adhered to it, and to condense and flatten it,
they take it down from the furnace to the floor, and boat it with large wooden
mallets having slender handles five feet long. Thereupon it is immediately
and again sometimes in twelve. In order that the heat of the fire should not
burn his face, he covers it entirely with a cap, in which, however, there are
holes through which he may see and breathe. At the side of the hearth is a
bar which he raises as often as is necessary, when the bellows blow too violent
a blast, or when he adds more ore and charcoal. He also uses the bar
to draw off the slags, or to open or close the gates of the sluice, through
which the waters flow down on to the wheel which turns the axle that com
presses the bellows. In this sensible way, iron is melted out and a mass
weighing two or three centumpondia may be made, providing the iron ore
was rich. When this is done the master opens the slag-vent with the tapping
bar, and when all has run out he allows the iron mass to cool. Afterward
he and his assistant stir the iron with the bar, and then in order to chip off
the slags which had until then adhered to it, and to condense and flatten it,
they take it down from the furnace to the floor, and boat it with large wooden
mallets having slender handles five feet long. Thereupon it is immediately
zoom in
zoom out
zoom area
full page
page width
set mark
remove mark
get reference
digilib